Fragen

Yes! The TapeTech 63TT and 68TT Nail Spotters can be used to touch up all aspects of your drywall finishing! Its light weight and ease of use make it a perfect tool to correct any small areas that may have been missed or were accidentally damaged between coats. Internal corners, external corners, flats and butt joints in drywall can all be touched up using the Nail Spotter. For touching up standard height ceilings, the HN handle that is included with both models works perfectly. For higher ceilings, you may need to use the HNRE extendable Nail Spotter handle ...

Pumping air into the TapeTech MudRunner...

If the needle (part #059049, often referred to as the gooser needle) that advances the drywall joint tape is ripping the tape when you use your TapeTech automatic taper, it is usually a sign that the taper needs cleaning or routine maintenance. First, check the needle; if it is worn it may need to be replaced. Make sure the needle is properly set in the needle holder (050050F) and adjust, if necessary.

Check to see that the drywall joint tape moves smoothly through the tape guide assembly (054101) and clean the assembly, if needed. For your convenience, TapeTech offers Maintenance Kit 200 ...

Absolutely. The Bazooka Continuous Flow Bazooka Taper T05CF weighs just 7 pounds, including a 250’ roll of tape! Compare this to a standard automatic taper that weighs approximately 18 pounds when fully loaded with joint compound and tape. The key difference is that the Continuous Flow Taper does not need to hold a reserve of joint compound; the joint compound flows continuously through the taper handle and onto the wall as you work. The taper handle is also smaller in diameter and more comfortable to operate for longer periods of time. Comfort, lower weight and no need to stop and refill constantly – continuous flow ...

The TapeTech Automatic Tapers (04TT and 05TT...